Product ID:EA 9309 NA, PART B
MSDS Date:03/01/1992
FSC:8040
NIIN:01-126-6270
Kit Part:Y
MSDS Number: BRHBJ

Emergency Phone: 510-458-8000

Info Phone: 510-458-8000

Cage: 33564

Telephone: 202-483-7616

Cage: 33564

DIETHYLENE GLYCOL DIAMINO PROPYL ETHER

CAS: 4246-51-9

RTECS: ID6475000

Fraction By Weight: 60-100%

<10 G/L (ESTIMATE)

RTECS: 9999999VO

Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE; THIS MATERIAL IS CORROSIVE TO
EYES AND SKIN. BRIEF CONTACT MAY CAUSE CHEMICAL BURNS. VAPORS AND
MISTS WILL IRRITATE NOSE AND THROAT.

CHRONIC; REPEATED/PROLONGED SKIN CONTACT MAY RESULT IN BURNS &
ALLERGIC SENSITIZATION.
Effects of Overexposure:SKIN OR EYE IRRITATION, CHEST DISCOMFORT.
Medical Cond Aggravated by Exposure:SKIN SENSITIZATION

First Aid:EYE: FLUSH EYES WITH LOTS OF RUNNING WATER FOR 15 MINUTES.
GET MEDICAL ATTENTION IMMEDIATELY. SKIN: WASH SKIN THOROUGHLY WITH
SOAP AND WATER. IF IRRITATION PERSISTS, GET MEDICAL ATTENTION.
INHALATION: REMOVE VICTIM TO FRESH AIR. IF SYMPTOMS PERSIST, GET
MEDICAL ATTENTION. INGESTION: DRINK PLENTY OF WATER. GET MEDICAL
ATTENTION IMMEDIATELY.

Flash Point Method:PMCC
Flash Point:261F,127C
Extinguishing Media:DRY CHEMICAL, HALON FIRE EXTINGUISHER, WATER SPRAY,
FOAM OR FOG
Fire Fighting Procedures:WEAR SCBA & FULL PROTECTIVE CLOTHING (TURN-OUT
GEAR). CARTRIDGE RESPIRATORS DO NOT PROVIDE ADEQUATE PROTECTION FOR
FIRE FIGHTERS OR EXOTHERM MITIGATION.
Unusual Fire/Explosion Hazard:MAY LIBERATE LARGE QUANTITIES OF DENSE
FOUL-SMELLING SMOKE WHICH MAY CONTAIN UNIDENTIFIED TOXIC GASES.

Spill Release Procedures:WEAR PROTECTIVE CLOTHING, GLOVES AND SAFETY
GLASSES. ABSORB SPILL WITH SORBENT MATERIAL SUCH AS VERMICULITE OR
SAND. SCRAPE UP OR SHOVEL INTO DOT APPROVED WASTE CONTAINERS.

Handling and Storage Precautions:MAY STORE AT ROOM TEMPERATURE FOR UP
TO 12 MONTHS. KEEP CONTAINER TIGHTLY CLOSED WHEN NOT IN USE. FOLLOW
CURING SCHEDULE & MIX RATIOS AS RECOMMENDED.
Other Precautions:SEE STABILITY SECTION OF MSDS. EMPTY CONTAINERS
RETAIN PRODUCT RESIDUE SO OBEY HAZARD WARNINGS AND HANDLE EMPTY
CONTAINERS AS IF THEY WERE FULL. DO NOT CUT, GRIND, WELD, OR DRILL
ON OR NEAR THIS CONTA INER.

Respiratory Protection:IF LOCAL EXHAUST VENTILATION IS INADEQUATE, A
RESPIRATOR EQUIPPED WITH ORGANIC VAPOR CARTRIDGE MAY BE
APPROPRIATE.
Ventilation:LOCAL EXHAUST VENTILATION AT THE POINT OF USE.
Protective Gloves:BUTY RUBBER, PVC, NITRILE RUBBER GLOVES
Eye Protection:SAFETY GLASSES W/SIDESHLD, CHEM GOGGLES
Other Protective Equipment:AN EYEWASH AND SAFETY SHOWER SHOULD BE
NEARBY AND READY FOR USE.
Supplemental Safety and Health
KEY1:C2.

HCC:V5
Vapor Pres:<0.4
Spec Gravity:1.02 (WATER=1)
Viscosity:0.02-0.05 P
Solubility in Water:100%
Appearance and Odor:REDDISH-ORANGE LIQUID WITH AMMONIACAL ODOR

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS, STRONG LEWIS OR MINERAL ACIDS.
Stability Condition to Avoid:AVOID MIXING RESIN (PT A) & CURING AGENT
(PT B) IN BATCHES > 1 LB UNLESS YOU USE IMMEDIATELY. DONT HEAT MIX
>125 F *
Hazardous Decomposition Products:CO, NOX, ALDEHYDES, ACIDS AND
UNDETERMINED ORGANICS
Conditions to Avoid Polymerization:* UNLESS CURING SURFACES TO BE
BONDED. FAILURE TO OBSERVE PRECAUTIONS MAY CAUSE HEAT BLDUP
(EXOTHERM-TOXIC GASES).

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.